Pressure Sensors

Pressure Sensors for gas or liquid test media


Presscision PT Sensors provide accurate measurement of pressure and ambient temperature using gas or liquid test media. Sensors are available in multiple pressure ranges to serve a variety of test applications. Recommended ranges and test applications include:

Model ppt-pt015: 0 to 15 psig

    • Fuel Gas tests (natural gas and propane)
    • Drain waste vent tests (DWV)


Model ppt-pt200: 0 to 200 psig

    • Fuel Gas tests (high pressure, commercial natural gas installations)
    • Drain waste vent tests (DWV)
    • Water supply tests
    • Fire suppression system tests
    • Medical Gas system tests
    • General leak detection testing


Other ranges up to 1000 psig are available.

Sensor Details

The Presscision PT Sensor is a small, rugged sensor designed to install directly to the plumbing under test, and provide accurate measurement of pressure and temperature using gas or liquid test media. The PT Sensor is supplied with a 7′ cable that connects it to the Presscision PPT base unit. The PT Sensor and associated cable connection are fully waterproof (IP67 rated).

All PT Sensors are factory calibrated using a NIST-traceable pressure standard. The calibration is performed just prior to shipping from the factory. A certificate of calibration is supplied with every Sensor. In order to maintain and document sensor accuracy, the factory strongly recommends a yearly re-certification of each PT Sensor.

15 PSIG Pressure Sensor

Measurement Specifications

All measurements are conducted using high quality instrumentation with traceable accuracy contained within the Sensor.

  • Pressure ranges:

Model ppt-pt015: 0 to 15 psig

Model ppt-pt200: 0 to 200 psig

Other ranges available on request:

Model ppt-pt300: 0 to 300 psig

Model ppt-pt600: 0 to 600 psig

Model ppt-pt1000: 0 to 1000 psig

  • Pressure accuracy: Grade A, +/- 1 % Full Scale
  • Temperature range: -40 to +257 deg F (-40 to 125 deg C)
  • Standards:

Manufactured in accordance with ASME B40.100

IP67 rated sensor and cable connector: fully submersible to 1.0 m for up to 30 minutes

Base Unit Interface

The PT Sensor interfaces to the PPT base unit via a supplied 7 ft cable. The cable provides all power, control and data interfaces for the Sensor.

Plumbing Interface

The PT Sensor incorporates a male 1/4″ NPT fitting for direct installation in the device under test. The PT Sensor installs in exactly the same manner as an analog pressure gauge.


  • Stainless steel Sensor body
  • Pressure connection: 1/4″ Male NPT
  • Waterproof: IP67 rated (including electrical connection at the Sensor)


  • Sensor: 2.25″ (l) x 0.94″ (dia)


  • Sensor : 0.15 lbs